Production Technician I, Dover

Work Location: 9 Roy Street ,Dover, NJ 07801-4308

1st Shift: Training for 3 weeks from 6:30am to 2:30pm. After training, hours will be on 2nd shift 2-10PM

POSITION OVERVIEW Provides support to wax assembly to ensure production targets are achieved. Operators will rotate thru sprue injection, plate making and Workcell job preparation (Kitting) in both DS and Equiax applications.

ENVIRONMENTAL HEALTH&SAFETY RESPONSIBILITIES• Expected to assist in the implementation of EHS Values and policy statements and accompanying principals. • Comply with all department, facility, corporate and regulatory EHS regulations. • Wear all required personal protective equipment (PPE). • Report all job-related illness and injuries (Per Employee Handbook).• Report all safety, health, and environmental concerns to your supervisor in a timely manner. • Attend all EHS training.

ESSENTIAL JOB FUNCTIONS• Assist in transporting cores/waxes between DS Wax and EQ Wax. • Provide Wax Cells with all materials needed to produce wax molds, including lot travelers, cups, sprues, prepared plates, ceramics, engraver numbers, patterns, and trucks. • Sprue injection • Must setup own dies and returnto proper location• Fill sprue presses with wax. • Read and interpret all setup drawings. • Prepare plates for use in D/S S/C Wax Assembly&over dipping of Wax Molds as needed.• Construct gates, sprues, runners, etc., when necessary. • Uses fixtures and plates as required by instruction. • Maintains own production records. • Works in safe manner, follows all applicable safety rules. • Maintain work area in a clean and orderly fashion.• Unload incoming shipments of materials. • Perform other duties as assigned by Group Leader or Supervisor. • Perform subassemblies and sprue preparation for Equiax Wax Work Cells. • Maintains Heijukka Board if in use • Frequent review of the assembly cell's needs • Assembly of thebase plates including adding wax to the base plate, attaching center poles, use of a torque wrench to tighten bolts;• Frequent carrying of both plates and finished molds to and from the assembly cells; • Maintaining any plate and pole storage area organized and taking material to and from those areas.

BASIC QUALIFICATIONS• Employees must be legally authorized to work in the United States. Verification of employment eligibility will be required at the time of hire. Visa sponsorship is not available for this position. • This position is subject to the International Traffic in Arms Regulations (ITAR) which requires U.S. person status. ITAR defines U.S. person as U.S. citizen, U.S. permanent resident (i.e. 'Green Card Holder').• No relocation benefit is offered for this position. Candidates residing within a 50 miles radius of Dover NJ will only be considered. • High School Diploma or GED from an accredited institution.

PHYSICAL DEMANDS/EQUIPMENT USED• Frequent standing or sitting. • Use of injection machines, computers, turn tables, hot knives and lifting devices. • Ability to lift up to 25 pounds